Lionel Andrés Messi Cuccittini é um futebolista argentino que atua como atacante. Atualmente joga pelo Paris Saint-Germain e pela Seleção Argentina, onde, atuando como capitão, venceu a Copa do Mundo do Catar de 2022. , but in Leo Messi Languare , languare , Diodo Láser: ¿Qué es y Cómo Funciona? mean??? mean?? : N Spaish , languare , Diodo Láser: ¿Qué es y Cómo Funciona? The laser diode is a light emitting diode like a normal LED light bulb, so we only need a few tens of ohm resistors to test it. Go out to the store and buy 5 70ohm 2W resistors and then attach them to a 3V or 6V or 12V source. Remember, with a diode smaller than 250mW, you should test at 6V so that the current is not too large, enough to test the laser light. Because if you choose 12V, the resistor will heat up very quickly and the bright laser light can be harmful to your eyes.
However, in order for it to be stable and brightness adjustable, An Khanh recommends that you install the circuit as follows:
Instructions for making your own laser engraving machine Aser diode An Khanh replaced with a laser because it has negative and positive pins (so it's easy to determine. The 10mfd capacitor is 10 uF big or smaller, but the bigger the better. The diode to prevent short circuit, place 2. 10ohm resistor connected to 5ohm in parallel, you can replace it with a 1 Ohm or 0.5Ohm resistor.At this level, the laser output current can only reach 200mA.The LM317 can bear a load of 1.5A so you don't need to worry. 7.2V, it outputs 200mA, if higher, the current is also higher, you should use a power meter to check before buying a laser.
Although this step is quite simple, it requires a lot of time because you can hardly buy a diode laser in 1 day.
How to control diode laser with Arduino?
Step 2: Buy a scanner (scanner) and control it
Please order 2 easy driver circuits, search on google to save time. If possible, buy a few small heatsinks attached to the IC. Easy driver that you can't find, you can find another way to drive any stepper motor controller that supports micro stepping and STEP and DIR control.
void setup() { (look at the pic.1)
pic.1
pinMode(8, OUTPUT);
pinMode(9, OUTPUT);
digitalWrite(8, LOW);
digitalWrite(9, LOW);
}
void loop() {
digitalWrite(9, HIGH);
delay(1);
digitalWrite(9, LOW);
delay(1);
}
Instructions for making your own laser engraving machine
Comments